ABB +P906 Manual page 14

14 Installation
•
d) Check the connection labelling for future reference.
1 V20
2 V10
•
e) Disconnect the cables from the control connections and then carefully remove
them from the drive module via the rubber grommet. Wind the cables carefully into
the plastic bag supplied, ready for installation later.
4. Remove the drive module from the packing carton. Continue with:
•
module installation: see the hardware manual,
•
installation and connections of the control unit: see section
control unit on page 15.
3 BPOW
4 BGDR
Installing the external