System Configurations - Kenwood TS-890S In-Depth Manual

System Configurations

The typical system configurations that use the TS-890S and Windows software are described below.
Refer to "TS-890S KENWOOD NETWORK COMMAND SYSTEM Setting Manual" which describes detailed information
on the configuration method for remote control.
■ Controlling the TS‑890S from an Adjacently‑placed PC (with a
Microphone Connected to the TS‑890S and an Internal Speaker)
● Using the LAN connector
Signal Type
Software
Control
ARCP-890
signal
Audio signal
Note:
◆ Configure "On (LAN)" in "KNS Operation (LAN Connector)" of the TS-890S.
● Using the USB connector
Signal Type
Software
Control Virtual COM port
signal driver and ARCP-890
Audio signal
Note:
◆ With these system configurations, the bandscope screen refreshes at a slower speed.
● Using the COM connector
Signal
Type
Software
Control
ARCP-890
signal
Audio signal
Note:
◆ With these system configurations, the bandscope screen refreshes at a slower speed
PC
Hardware
-
- -
PC
Hardware
-
- -
PC
Hardware
-
- -
Connection
Method
LAN Cable Connect to the LAN connector
No Microphone connected to the TS-890S
connection
Connection
Method
USB cable Connect to the USB‑B connector.
No Microphone connected to the TS-890S
connection
Connection
Method
RS-232C
Connect to the COM connector.
cable
No Microphone connected to the TS-890S
connection
Software 09
TS‑890S
Hardware
and internal speaker
TS‑890S
Hardware
and internal speaker
TS‑890S
Hardware
and internal speaker
67