Panasonic AFPX-COM5 User Manual page 14

Setting for using the general-purpose serial communication (Ethernet)
The following two settings for the FP-X and communication cassette AFPX-COM5 should be set.
- Communication environment of FP-X
- Communication environment of Communication cassette AFPX-COM5
Setting communication environment of FP-X
The programming tool FPWIN GR is used to set the baud rate or communication format of the COM1
port. Select [Option] → [PLC Configuration] in the menu bar, and click [COM1 Port ] tab.
Dialog box of PLC system register setting
COM1 port setting (AFPX-COM5)
No. Setting item
No.410 Unit number
No.412 Communication mode
No.413 Communication format
No.415 Baud rate
Note1) Set the baud rate to match the baud rate (COM1 port) of the AFPX-COM5.
Setting Ethernet communication environment of Communication cassette AFPX-COM5
The Configurator WD is used to set Ethernet communication environment of the AFPX-COM5.
Reference: <7.7.3 Communication Tool Software Configurator WD>
Start the Configurator WD.
Search the AFPX-COM5.
Select the AFPX-COM5 from the search result, and set an IP address to connect wit a computer.
After that, search again. Select the AFPX-COM5, and select [Edit] → [Communication Setting] in the
menu, or right-click to select [Communication Setting].
14
Buy: www.ValinOnline.com | Phone 844-385-3099 | Email: CustomerService@valin.com
Setting value
1 to 99
General communication
Characer bit 8 bits
Parity check Odd
Stop bit 1 bit
Terminator CR, CR+LF, None
Header STX not exist, STX exists
115200 bps/9600 bps
Note1)