Table 2. Indications About Failure Condition - Motorola MW800 Series Manual

44

Table 2. Indications about failure condition

Indication
Power LED is off
Power LED is steady yellow
Temperature LED blinks red
Temperature LED blinks yellow
Communication LED is steady
blue
Communication LED is steady
yellow
Communication LED is steady
purple
Link LED is yellow & green
The following table describes MW800 failures without a user notification.
Table 3. MW800 failures without user notification
Problem
Cannot turn the device off, the
system does not respond
What's the problem
Check the plug and the power cord.
Vehicle battery is low (9.4 to 10.3 VDC)
during workstation power up.
Display temperature is extremely high during
power on
Display temperature is extremely low during
operation.
CPU box to display USB power problem, or
display in programming mode. Check the plugs
and CPU cable.
CPU box fails to communicate with display.
Check the plugs and CPU cable.
CPU box to display USB power and
communication problem. Check the plugs and
CPU cable.
NO valid input signal from CPU box. Check
the plugs and CPU cable.
Do the following
Turn off the device by pressing and holding the
power button for 6 seconds or more. Use either
CPU or display power buttons.
If the device is still not responding, turn off
and on the main power switch on the rear side
of the CPU unit.