Adjusting The Maximum Ground Speed - Toro Groundsmaster 7210 Series Operator's Manual

WARNING
The electrical system does not perform
proper safety shutoff with the jumper
wire installed.
• Remove the jumper wire from the
wire harness connector and plug the
connector into the seat switch when
you complete adjustment.
• Never operate the machine with the
jumper installed and the seat switch
bypassed.
13. Lower the seat into position.
14. Remove the jack stands.
Adjusting the Maximum
Ground Speed
1. Disengage the PTO, move the motion-control
levers to the N
EUTRAL
engage the parking brake.
2. Move the throttle lever to the S
shut off the engine, remove the key, and wait
for all moving parts to stop before leaving the
operating position.
3. Remove the bolts securing the front panel and
remove the panel
2
1
Figure 81
1. Bolt
2. Control panel
4. Loosen the jam nut on the stop bolt for a control
lever (Figure 82).
- position, and
LOCK
position,
LOW
(Figure 81).
G020875
1. Stop bolt
2. Control lever
5. Thread the stop bolt all the way in (away from
the control lever).
6. Push the control lever all the way forward until it
stops and hold it there.
7. Thread the stop bolt out (toward the control
lever) until there is a gap of 1.5 mm (0.060
inch) between the head of the stop bolt and the
control lever.
Note:
If you want to reduce the maximum
machine speed, back each stop bolt out an
equal amount toward the control lever until you
reach the desired maximum speed. You may
need to test your adjustment several times.
8. Tighten the jam nut to secure the stop bolt in
place.
9. Repeat steps
lever.
10. Install the front panel.
11. Ensure that the machine drives straight and
does not turn when both control levers are
pushed all the way forward.
Note:
If the machine turns, the stop bolts are
not evenly set and you need to adjust them
g020875
further.
58
Figure 82
3. Jam nut
4. 1.5 mm (0.060 inch)
4 through 8 for the other control
g004766