Typical Installation in a VME Card Cage
Model 744 Installation
Model 744 Installation
Tools Required
Model 744 installation requires the following tools:
Static grounding wrist strap
(supplied with the installation kit)
No. 1 Pozidriv screwdriver
5 mm (3/16 inch) nutdriver
Light-duty flat-tipped screwdriver
Preliminary Requirements
Perform the following procedure before you install the board computer into
the VME card cage:
1 Read the steps in "Configuring the VME Card Cage," earlier in this chap-
ter.
Installing a Single-Slot Model 744 into an HP Card Cage
Follow these steps to install the Model 744 into the VME card cage:
1 Position the board computer at the desired slot and slide it into the card
cage until it seats properly and the front panel is flush against the card
cage.
2 Push both ejector levers in until they are flush with the front panel.
3 Engage and tighten the captive screws (labeled 1 and 2 in Figure 3-2) at
each end of the board computer. These screws hold the computer in the
VME card cage.
3-8
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
Tool
Preventing static discharge problems
Attaching accessory cards
Attaching accessory cards
Attaching accessory cards
Used For