Leds; Radio Port 230 Leds; Startup - HP ProCurve Radio Port 230 Installation And Getting Started Manual

LEDs

Each radio port has LEDs on the front of the case that display the device status.
The LEDs display connection status and error conditions, as well as network
activity for the individual radios in the radio port.

Radio Port 230 LEDs

The Radio Port 230 has two LEDs displaying connection status, error
conditions, and networking activity for each of the two radios. Operation
is as follows:

Startup:

Radio Port Startup occurs immediately following the application of PoE
power, or following a power or software reset.
1. Both GREEN and AMBER LEDs light steadily for several seconds, while
the radio port performs an internal self-test.
2. The AMBER LED then flashes 3 times per second, while the GREEN LED
is off. This indicates that the radio port is attempting to communicate to
a compatible wireless services-enabled switch.
3. Both LEDs then go off for a moment, followed by both LEDs lighting
steadily for a few seconds.
4. After this sequence, assuming no error conditions have occurred, the
radio port enters Normal operation mode. This indicates the radio port
has successfully communicated with and been adopted by a wireless
services-enabled switch. If this startup sequence repeats itself, it is likely
the radio port is unable to contact a compatible wireless services-enabled
switch, and the installer should review the Troubleshooting section.
LEDs
Introduction
LEDs
1-5