•
Put the boundary wire 30 cm / 12 in. (C)
from an obstacle that is 1-5 cm / 0.4-2 in.
high.
•
Put the boundary wire 10 cm / 4 in. (D) from
an obstacle that is less than 1 cm / 0.4 in.
•
If you have a paving stone path that is in
level with the lawn, put the boundary wire
below the paving stone.
Note: If the paving stone is minimum 30 cm /
12 in. wide, use the factory setting for the
Drive Past Wire function to cut all the grass
adjacent to the paving stone.
CAUTION: Do not let the product
operate on gravel.
•
If you make an island, put the boundary wire
that runs to and from the island near
together (E). Put the wires in the same
stake.
•
Make an eyelet (F) where the guide wire is
to be connected to the boundary wire.
CAUTION: Do not make sharp
bends when you install the
boundary wire.
CAUTION: For careful operation
without noise, isolate all obstacles
such as trees, roots and stones.
3.3.3.1 To put the boundary wire in a slope
The product can operate in slopes. Slopes that
are too steep must be isolated with the boundary
wire. The gradient (%) is calculated as height per
m. Example: 10 cm / 100 cm = 10%.
18 - Installation
35 cm / 14"
> 5 cm/>2"
•
For slopes steeper than 25% inside the work
area, isolate the slope with boundary wire.
•
For slopes steeper than 10% along the outer
edge of the lawn, put the boundary wire 20
cm / 8 in. (A) from the edge.
•
Slopes adjacent to a public road must be
isolated with boundary wire. Put a fence or a
protective wall along the outer edge of the
slope.
3.3.3.2 Passages
A passage is a section that has boundary wire on
each side and that connects 2 work areas. The
passage must be a minimum of 60 cm / 24 in.
wide.
Note: If a passage is less than 2 m / 6.5 ft. wide,
install a guide wire through the passage.
3.3.3.3 To make an island
•
Put the boundary wire to and around the
obstacle to make an island.
•
Put the 2 sections of boundary wire that run
to and from the obstacle together.
•
Put the 2 sections of boundary wire in the
same stake.
0-15%
100 cm / 40"
>15%
A
0-15 cm / 0-6"
1220 - 001 -