Mitsubishi Electric MELSEC iQ-R Series User Manual page 88

■[Diagnostic] tab
The connection status of the EtherNet/IP device is displayed.
This tab can be used when diagnostic mode is enabled. ( Page 114 Network diagnostics of EtherNet/IP Configuration
Tool)
To display this content, 'EtherNet/IP communication start request' (Y10) must be turned off and on and
'EtherNet/IP communication in process' (X10) must be in the ON state.
(1)
No. Item
(1) Connection list
(2) Refresh Every
(3) Connection information
(4) Status
• Diagnostic information window
Item
Status Input Status
Output Status
General
Extended
3 EtherNet/IP Configuration Tool
86
3.1 Window Structure
Description
Displays the names of the connections set on the [Connections] tab.
Diagnostic information is displayed in the connection information when
"Monitor Data And External Input" is selected.
I/O data is displayed in the connection information when "IO Data" is
selected.
Connection information content is updated at 500ms intervals when this
check box is selected.
The update count is incremented each time the information is updated.
Displays the diagnostic information and I/O data.
Displays the connection status.
*2
*2
Description
Displays the internal status code of the input connection.
Displays the internal status code of the output connection.
Displays the CIP general status code.
Displays the CIP extended status code.
(2)
(3)
(4)
Setting range

• Selected
• Not selected
(Default: Selected)


*1
*1