Toro Sand Pro 5040 Operator's Manual page 9

new valve and the vacated fitting on the existing
lift valve (Figure 15).
6. Connect the 45-degree fitting end of hydraulic
hose, Part No. 108-8449, to the 90-degree fitting
on the right side of the valve and the straight
end of the hose to the vacant oil cooler fitting
(Figure 15). Refer to
for hose routing.
7. Mount the wire hose holder to the left frame tube
with 2 thread-forming screws (5/16 x 3/4 inch);
refer to Figure 15.
8. Connect the short 90-degree fitting end of
hydraulic hose, Part No. 108-8453, to the top
straight fitting on the rear of the valve. Route the
hose through the wire hose holder and connect
the straight end of the hose to the top hydraulic
1. New valve
2. Tube assembly (Part No.
108-8447)
Figure 16 and Figure 17
3. Existing valve
4. Hydraulic hose (Part No.
108-8449)
cylinder fitting
and Figure 17
9. Connect the long 90-degree fitting end of the
hydraulic hose, Part No. 108-8454, to the bottom
straight fitting on the rear of the valve. Route the
hose through the wire hose holder and connect
the straight end of the hose to the bottom
hydraulic cylinder fitting
Figure 16 and
Important:
routed away from any sharp, hot, or moving
components.
10. Tighten all fasteners and fittings.
11. Using cable ties, secure the hoses to the
machine at the locations shown in
Figure 17.
Figure 15
5. Wire hose holder
6. Hydraulic hose (Part No.
108-8453)
9
(Figure 15). Refer to
for hose routing.
(Figure 15). Refer to
Figure 17 for hose routing.
Make sure that the hoses are
Figure 16
7. Hydraulic hose (Part No.
108-8454)
Figure 16
and
g003672