Toro Sand Pro 5040 Operator's Manual page 7

Figure 9
1. Hitch frame bracket
2. Hitch frame
8. Secure the frame adapter to the hitch frame with
a tube, a clevis pin, and a cotter pin
Figure 10
1. Frame adapter
2. Tube
g018349
3. Hitch frame tube
(Figure 10).
g018307
3. Clevis pin with grease
fitting
Important:
Ensure that the existing hoses
are routed above the guide, as shown in
Figure 11.
6
Installing the Hydraulic
Cylinder
Parts needed for this procedure:
1
45-degree hydraulic fitting with O-ring
1 Hydraulic cylinder
1 90-degree hydraulic fitting with O-ring
1 Small retaining ring
1 Pin
2 Large retaining ring
Procedure
1. Thread a 90-degree fitting into the upper port
in the hydraulic cylinder. Position the fitting as
shown in Figure
Note:
Make sure that all O-rings are lubricated
and properly positioned on fittings before
installation.
Note:
To prevent contamination to the hydraulic
fittings or hoses, do not remove the caps from
the fittings or hoses until they are installed.
2. Thread a 45-degree fitting into the lower port
in the hydraulic cylinder. Position the fitting as
shown in Figure
7
Figure 11
12.
12.
g028340