Output Test; Input Test - Bosch ACS 561 Repair Instructions

ACS 561 Service Manual

Output Test

The Output Test checks the electrical outputs
from the power board and wiring harnesses to
the various solenoids, fan, vacuum pump, and
compressor. This test is useful as a trouble-
shooting method to determine if a device is
operating properly or not.
1. From the Service Menu, scroll to Output
Test.
2. Press Select (F1). The following displays:
The placeholder "X" indicates the state of the
output device. A "1" or "0" indicates whether
the device is ON or OFF. A list of the tests is
provided in the table below:
OUTPUT TEST
S1 Recover Solenoid
S2 Vacuum Solenoid
S3 Charge Solenoid
S4 ISV Liquid Solenoid
S5 Oil Inject Solenoid
S6 Oil Drain Solenoid
S7 Oil Return Solenoid
S8
S9
S10
S11
Robert Bosch GmbH
Unused
Unused
Unused
Unused
Diagnostics and Testing
OUTPUT TEST
FAN
PUMP
COMP
Beacon
Beeper
3. As the tests are highlighted, press On/Off.
The state will change from "0" to "1". There
should be a "click" heard as the solenoids
are energized, the motors of the fan, vacu-
um pump, and compressor should start, the
beacon, if installed will flash once, and the
beeper will sound.
4. When the test is complete, press Exit (F2)
to return to the Service Menu.

Input Test

The Input Test presents a present value of the
many parameters the control board processes
to correctly operate the unit. The parameters
shown in this test are observable only and can-
not be changed or deleted. They can be used
to indicate whether or not a parameter is within
the required limits for proper unit operation.
1. From the Service Menu, scroll to Input Test.
2. Press Select (F1). The following displays:
The placeholders "X" and "Y" represent actual
values seen during this test. A list of the param-
eters and what the values represent follows:
27
Fan
Vacuum Pump
Compressor
Unused
Beeper
SP00D00517 2018-07-11