Assembly; Assembling The Meat Grinder; Assembling The Sausage Stuffer Attachment; Assembling The Kibbeh Attachment - Silvercrest SKV 1200 A1 Operating Instructions Manual

Assembly

Assembling the meat grinder

Refer to the section "Component description, meat
grinder".
1) Place the transport screw
2) Then insert the mincing knife
with the knives is facing away from the trans-
port screw . Ensure that the angled recess
of the mincing knife
angled axle.
3) Select the required perforated disc
4) Place the selected perforated disc
housing so that the fixture on the housing
grips into the recess on the edge of the perfo-
rated disc / .
5) If everything is correctly inserted, screw the
locking ring hand tight.
The attachment can now be connected to the food
processor (see section "Fitting onto the food processor").
Assembling the sausage stuffer
attachment
Refer to the section "Component description, sau-
sage stuffer attachment".
1) Place the transport screw
2) Then fit the spacer
on the housing
edge of the spacer
3) Then fit the sausage stuffer spout
the spacer .
4) Screw the locking ring
The attachment can now be connected to the food
processor (see section "Fitting onto the food processor").
SKV 1200 A1 - C
in the housing
so that the side
lies correctly on the
/ .
/ into the
in the housing
. Ensure that the fixture
clicks into the recess on the
.
in front of
hand-tight.

Assembling the kibbeh attachment

Refer to the section "Component description, kib-
beh attachment".
1) Place the transport screw
2) Insert the kibbeh disc
on the housing
.
edge of the kibbeh disc
3) Then place the kibbeh funnel
kibbeh disc
4) Screw the locking ring
The attachment can now be connected to the food
processor (see section "Fitting onto the food processor").
Assembling the spritz cookie attach-
ment
Refer to the section "Component description, spritz
cookie attachment".
1) Place the transport screw
2) Then fit the spacer
on the housing
edge of the spacer
3) Now place the pattern strip holder
spacer . Ensure that the recess on the edge
of the pattern strip holder
of the spacer
.
4) Screw the locking ring
5) Push the pattern strip
holder until the desired pattern lies over the
opening in the pattern strip holder
The attachment can now be connected to the food
processor (see section "Fitting onto the food processor").
in the housing
. Ensure that the fixture
grips into the recess on the
.
in front of the
.
hand-tight.
in the housing
. Ensure that the fixture
clicks into the recess on the
.
lies on the latch
.
hand-tight.
into the pattern strip
GB │ IE │ NI │ CY
.
.
on the
.
│ 9 ■