Com2 - GE MDS RCL220 Manual

RCL220_manual_v3-draft.doc
DISABLED
DATA
INT_LOOP
EXT_LOOP
MDM_DEBUG
BAUD=<baud> Read / Write. Set / display baud rate setting.
1200
2400
4800
9600
19200
38400
57600
115200
230400
FORMAT=<format> Read / Write. Set / display characters, parity, and stop bits
setting of the COM port. '8N1' format.
7N1 7 char bits, no parity, 1 stop bit
7N2 7 char bits, no parity, 2 stop bits
7O1 7 char bits, odd parity, 1 stop bit
7O2 7 char bits, odd parity, 2 stop bits
7E1 7 char bits, even parity, 1 stop bit
7E2 7 char bits, even parity, 2 stop bits
8N1 8 char bits, no parity, 1 stop bit
8N2 8 char bits, no parity, 2 stop bits
8O1 8 char bits, odd parity, 1 stop bit
8O2 8 char bits, odd parity, 2 stop bits
8E1 8 char bits, even parity, 1 stop bit
8E2 8 char bits, even parity, 2 stop bits
CMD=<cmd> If set to 0, the command executes normally. If <cmd> is set to 1, the
command reports all settings in a format that may be copied into a configuration
script.

3.2.4 COM2

Usage: COM2 {DEFAULT=<default>} {MODE=<mode>} {LEVELS=<levels>}
{BAUD=<baud>} {FORMAT=<format>} {DUPLEX=<duplex>} {CMD=<cmd>}
Description: Set / displays configuration of COM2.
NOTE: CMD=1 short form response command is supported.
05-XXXXA01 Version 3 Draft
Com1 data mode disabled
Com1 in Reserved BSP PRAD Data mode
Com1 in Internal Loopback mode. <Distributor access level>
Com1 in External Loopback mode <Distributor access level>
Com1 in MoDeM Debug mode
1200 bps
2400 bps
4800 bps
9600 bps
19200 bps
38400 bps
57600 bps
115200 bps
230400 bps modem debug only
Page 33 of 79 9/20/2016