Using The Player On Batteries - Sony CFD-980 Operating Instructions (English, Español) Operating Instructions Manual

Choosing the power sources (continued)
Tip
Replace the batteries
when the OPR/BATT
indicator dims or
when the player stops
operating. Replace all
the batteries with new
ones. Before you
replace the batteries,
be sure to take out the
CD from the player.
Notes
• Use only the supplied
car battery cord (DCC-
EC9). Do not use any
other car battery cord.
Polarity of the plug
• Use the supplied car
battery cord only with
a negative '
grounded car that
uses a 12 V battery.
• If the inside of the
cigarette lighter socket
is dirty with ashes,
etc., the plug of the car
battery cord may
become heated due to
a bad contact. Before
connecting the cord,
be sure to clean the
socket.
• When listening to the
radio on this player,
the car battery cord
may cause noise.
Extend it as long as
possible, and keep it
as far away as possible
from the player.
26 EN
Setting Up

3 Using the player on batteries

Insert six R20 (size D) batteries (not supplied) into the
battery compartment.
To use the player on batteries, disconnect the AC
power adaptor from the player.
4 Using the player on car battery
Insert one end of the supplied car battery cord (DCC-
EC9) to the DC IN 9 V socket located on the side of the
player, and the other end to a cigarette lighter socket.
To a cigarette lighter socket
To replace the fuse of the car battery cord
Be sure to use the fuse with the correct amperage.
(4A, 125 V, length 31.75 mm)
Remove
Plug end
Tighten
DC IN 9 V
Fuse
Cigarette lighter plug