Motorola R-2002A Manual page 237

· Accept transponded SAT as an indication of mobile
confirmation. •
Send alert order.
Accept signaling tone (10KHZ) as confirmation of alert
order.
Send power level command. High power.
Accept order confirmation. Manual power level testing
permitted. Select power levels 0-7.
Verify order confirmation.
Handoff testing permitted. Select FVC.
Confirm 50 msec signaling tone time for the handoff.
Switch to the new FVC.
SAT drop testing permitted. Select a new SAT frequen-
cy (1-3).
Repeat power level and/or handoffs above as described.
Temporary exists allowed to analyze signals using the
other R2008D/R2010I? modes.
26
Perform initial voice channel confirmation subtask.
A. Tune receiver to R2008D/R2010D FVC.
B. Adjust transmit frequency to RVC.
C. Adjust rf power to VMAC.
D. Turn on SAT.
E.
Set DSCMM to SCC.
....
Enter waiting for order task.
Receive alert order.
A. Turn on 10 KHZ signaling tone.
B. Generate "ring".
Enter wattmg for answer task. A Maximum of 65
seconds allowed for answer.
Off hook (mobile is answered). Signaling tone is turned
off.
Enter conversation task.
A. Set audio mode to conversation.
B. Two way audio conversation now in progress.
Adjust power level to that requested and send order
confirmation.
Adjust power level to that requested and send order
confirmation.
Send a 50 msec signaling tone as a confirmation.
Change to the new RVC.
If a new SAT selected, the mobile should stop transmit-
ting after 5 seconds.