Mitsubishi Electric RD78G4 User Manual page 60

Item
Network Total Slave Stations
Status (Parameter)
Total Slave Stations
(Connected)
Communication Cycle
Interval Setting value
Number of Station
Errors Detected
Change IP Address
Display
Network map
Data Unlinked Station
Monitor
Selected Station Communication
Status Monitor
Operation [Communication Test]
Test button
Selected [Remote Operation]
Station button
Operation
3 TROUBLESHOOTING
58
3.3 Checking the Network Status
Description
Displays the total number of slave stations set in "Network Configuration Settings" under "Basic Settings".
Stores the total number of slave stations (number of slave stations) that are actually connected by data link in the CC-
Link IE TSN.
The communication cycle interval set in "Communication Period Setting" under "Basic Settings" of the master station is
displayed. (s unit)
Indicates the number of error stations in the displayed network.
Allows to select from "DEC" or "HEX" for IP address display on the selected communication status monitor and
network map. (Default: Decimal)
Indicates the CC-Link IE TSN structure and the status of each station. ( Page 59 Network map)
If the status of each station is not displayed, check whether there are any duplications of master stations.
Displays a disconnected station that has been set in "Network Configuration Settings" under "Basic Settings" but has
not yet performed data link. Error invalid stations are also included.
However, even if a disconnected station had performed data link, disconnected stations in the following cases are
displayed in this area.
• A station that was reconnected to a network after disconnecting/inserting the cable or powering off and on the
system, and remains disconnected
• A disconnected station with the station icon deleted in the network map by clicking the [Update] button
Displays the St. info which is selected in "Station infomation switching" and the station No. on the station icon.
The "Other Modules" icon indicates a station that has not yet performed data link.
Icons other than the "Other Modules" icon indicate stations that had performed data link before disconnection.
For details on the displayed icon, click the [Legend] button.
Displays status of the station selected in "Network Status". ( Page 61 Selected Station Communication Status
Monitor)
Performs a communication test. ( Page 62 Communication Test)
Performs remote operation (such as RUN, STOP, or RESET operations) to the CPU module. (Page 63 Remote
Operation )