TIP
A special wrench can be obtained at a
Yamaha dealer to make this adjustment.
Standard position: B
A- Minimum (soft)
E- Maximum (hard)
1. Special wrench
5UG1B001
Adjusting the front shock absorber
assemblies (YX70SSD)
WARNING
These shock absorber assemblies contain
highly pressurized nitrogen gas. Read and
understand the following information be-
fore handling the shock absorber assem-
blies.
Do not tamper with or attempt to open
●
the cylinder assemblies.
Do not subject the shock absorber as-
●
semblies to an open flame or other
high heat source. This may cause the
unit to explode due to excessive gas
pressure.
Do not deform or damage the cylin-
●
ders in any way. Cylinder damage will
result in poor damping performance.
4-24