Cisco PowerVu D9858 Installation And Operation Manual page 192

DPM Default Settings for Different Output Modes,
The fields labelled "Any" in the table below, are 'don't care' parameters, in which
case, the Output Mode will not change if the parameter is changed. However, if you
change any of the other parameters listed in the table for the MAP or Transcoding
output modes, the Output Mode will change to Full DPM Control.
Output No Output
Mode
Rate Control Any
User Rate Any
Descramble Any
Mode
Regenerate Any
Insert Null Any
Packet
Map Mode Svc ID
Duplic PSI Remap
Mode
Unref Drop
PSI Options Drop
PSI Rate SA Std
Svc ID Valid Ch
PAT Pass
CAT Pass
PMT Pass
TSDT Pass
NIT Pass
NITO Pass
B-10 Model D9858 Advanced Receiver Transcoder Installation and Operation Guide
Passthrough Service
Chans Only
Any Any
Any Any
Any Any
Any Any
Any Any
Svc ID Svc ID
PSI Remap PSI Remap
Pass Drop
Ctl By Table Ctl By Table
SA Std SA Std
Valid Ch Valid Ch
Pass Regen
If Descramble If Descramble
Mode is set to Mode is set to
Descrambled, Descrambled,
it is set to it is set to
Regen; Regen;
otherwise, it is otherwise, it
set to Pass is set to Pass
If Descramble If Descramble
Mode is set to Mode is set to
Descrambled, Descrambled,
it is set to it is set to
Regen; Regen;
otherwise, it is otherwise, it
set to Pass is set to Pass
Pass Pass
Pass Regen
Pass RwRC
Continued
MAP MAP Svc
Passthrough Chans Only
Any Any
Any Any
Any Any
Any Any
Any Any
Svc ID & PID Svc ID & PID
PSI Remap PSI Remap
Pass Drop
Ctl By Table Ctl By Table
SA Std SA Std
Valid Ch Valid Ch
Regen Regen
Regen Regen
Regen Regen
Pass Pass
Regen Regen
PwRc PwRC
Transcoding
Any
Any
Descrambled
Any
Any
Svc ID & PID
Pkt Copy
Drop
Ctl By Table
SA Std
Valid Ch
Regen
Regen
Regen
Pass
Regen
PwRC
4023074 Rev B