Cisco PowerVu D9858 Installation And Operation Manual page 110

Setup Menu: Outputs: TS Out: DPM,
Global
Resync All:
Description:
Parameters:
Copy:
Description:
Parameters:
ASI/MOIP1
PE
Description:
Parameters:
InCh
Description:
Parameters:
PMT
Description:
Parameters:
Act
Description:
Parameters:
Id
Description:
Parameters:
OutCh
Description:
Parameters:
4-58 Model D9858 Advanced Receiver Transcoder Installation and Operation Guide
Continued
This resynchronizes all DPM output with the PMT data for all
program entries.
ASI or MOIP1.
This copies all DPM data from either the ASI output to the MOIPI
output (MPEG over IP) or from the MOIPI output to the ASI output
depending on your selection.
ASI->MOIPI or MOIPI->ASI.
This selects the DPM Program Entry to view/modify.
1. Default is 1.
Displays the input channel of the current PE.
1 to 65535.
This is the input PMT. This value is only to map to the output PMT
if the PE Action is set to MAP.
1 to 8192.
Selects the DPM action for the PMT associated with the PE.
Pass, Drop, Map or Xcode. The default is Pass.
Selects the transcoder when Act is set to XCode.
1 or 2.
This selects the DPM output channel you want to map to the input
channel (InCh). This value is only used if the PE Action is set to
MAP.
1 to 65535.
4023074 Rev B