Siemens SIMATIC S5 Equipment Manual page 144

R 02/92
KB : Output of identifier bits, or
: Output of identifier bits (High word) -t Channel 2
: Output of identifier bits (Low word) + Channel 1
ST : Output of control bits
Both setpoints must be specified per track.
The track is deleted for interrupt identifier KH = FFFE
KY = x, y x = 32: Zero shift, Channel 1
KB
: Output of identifier bits, or
: Output of identifier bits (High word) -t Channel 2
Output of identifier bits (Low word) -+ Channel 1
ST : Output of control bits
If BEF=SH, the zero shift values are transferred without an SS bit; this is
the precondition for hardware– based synchronizing with preliminary contact and
zero mark (see operating instructions).
If BEF=SS, the zero shift values are transferred with an SS bit; this ac–
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
x = 33: Zero shift, Channel 2
Programming Instructions
9 – 23