Setting The Module Address - Siemens SIMATIC S5 Manual

3.4.1 Setting the Module Address

Each temperature controller module 244 requires 32 addresses for transferring the necessary
parameters. Only the start address of each module must be set. The next 31 addresses are
assigned by internal decoding and are no longer available to other modules. The addresses can
be selected in multiples of 32.
DIL switch A 76
for ADB 8 ... 11
Example:
The start address of the temperature controller module is n = 160 in the P area of the CU.
Set the switches as follows:
IP244B
C79000–B8576–C865–01
DIL switch A 77
for ADB 5 ... 7
Operation
3–27