Installing S5 Modules In Adapter Casings - Siemens SIMATIC S5 Manual

Adapter Casing (S5 Adapter)
1.3 Installing S5 Modules in an Adapter Casing
Procedure
To install an S5 module in an adapter casing, use the following procedure:
1. Select an alarm line and thus the target CPU for alarms on the module
2. Remove the locking strap from the adapter casing.
3. Insert the module into the guide rails of the adapter casing and push it in.
4. Re-install the locking strap.
5. If your S5 module is equipped with a locking screw, push the locking
Fig. 1-2 shows how you install an S5 module in an adapter casing.
Bild 1-2
7–6
(alarm-triggering modules only).
Alarm line...
/INT A
/INT B
/INT C
/INT D
The rear connectors make contact with the sockets of the adapter casing.
screw in and turn the slot into a vertical position.
Locking strap
Installing an S5 module in the adapter casing
... corresponds to target CPU
CPU 1
CPU 2
CPU 3
CPU 4
Locking screw
(not in all modules)
C79000–B8576–C866–01
IP244