Advertisement
Cleaning the TOSHIBA Label Printer for Business Partner Systems
Model #B-EV4D-GS24
Step 3 — Clean the Linerless Cutter Block
1. The TOSHIBA Label Printer must remain powered OFF before continuing with
this Step.
2. Lift the Linerless Cutter Block on the front of the printer by lifting up on both
sides. Lay the cutter down in order to clean the inside, being careful not to
break the plastic label tray that sticks out in front.
3. Slide the lock levers in the direction indicated by the arrows by pushing against
the raised back edge of each lever.
Figure 7: Lock Levers – Left: Locked Position Right: Unlocked Position
November 2016
Figure 6: Linerless Cutter Block
Raised edge
Always follow instructions to ensure the protection of personnel, devices, and data
LIMITED RIGHTS NOTICE
Lock levers
V2.1
Page 6 of 16
Advertisement
