Advertisement
Cleaning the TOSHIBA Label Printer for Business Partner Systems
Model #B-EV4D-GS24
9. Reattach the Linerless Cutter Block to its original position on the front of the
printer as follows (see Figure 13):
Align and ensure that the bottom hooks slide into the bottom slots, and that
the two upper hooks slide into the upper slots as indicated by the yellow and
red arrow stickers on the sides of the printer.
If you encounter difficulty aligning these hooks and slots, check that the
electric wire from the printer is not interfering with the alignment.
Once everything is properly aligned, push down firmly.
To verify proper attachment, close the printer cover. If the cover closes
properly, the Linerless Cutter Block is properly attached. If not, remove the
Cutter Block and repeat instruction 9.
Once proper attachment is confirmed, reopen the printer cover.
10.
Continue to Step 4.
November 2016
Figure 13: Hooks and Slots on Label Printer
Always follow instructions to ensure the protection of personnel, devices, and data
LIMITED RIGHTS NOTICE
V2.1
Page 10 of 16
Advertisement
