Mains Connection And Line-Side Power Components; Introduction - Siemens SINAMICS S120 Manual

Mains connection and line-side power components

3.1

Introduction

The following line-side components should be used to connect a SINAMICS drive line-up to
the supply network:
● Line disconnector
● Overcurrent protection device (line fuses or circuit-breaker)
● Line contactor (this is required for electrical isolation)
● Line filter (optional)
● Line reactor for FSA to FSC (optional)
The possible supply voltages for the drive line-up are:
● For PM240-2 FSA, FSB and FSC Power Modules, blocksize format:
– 1 AC 200 V to 1 AC 240 V ±10 %
– 3 AC 200 V to 3 AC 240 V ±10 %
– 3 AC 380 V to 3 AC 480 V ±10 %
● For PM240-2 FSD, FSE and FSF Power Modules, blocksize format:
– 3 AC 200 V to 3 AC 240 V ±10 %
– 3 AC 380 V to 3 AC 480 V ±10 %
– 3 AC 500 V to 3 AC 690 V ±10 %
● For Power Modules, chassis format:
– 3 AC 380 V to 3 AC 480 V ±10 %
The following line reactor variants are available:
● 4 versions for chassis format
● 4 versions for chassis format
The following line filter variants are available:
● Integrated versions for the blocksize format to comply with EMC category C2 or C3
● External versions for the chassis format to comply with EMC category C2 or C3
AC Drive
Manual, (GH6), 07/2016, 6SL3097-4AL00-0BP5
3
43