Huawei USG6000 Series Hardware Manual page 317

HUAWEI USG6000 Series
Hardware Guide
Step 3 Before connecting an optical fiber, attach temporary labels to both ends of the optical fiber for
identification.
Step 4 Remove protective caps from optical fiber connectors, insert optical fibers into the optical
transceiver, and connect the fiber to the peer device.
Ensure that the TX and RX ports on one end of the optical fiber cable are connected to the RX
and TX ports (respectively) on the other end.
Figure 3-52 Installing optical transceivers and connecting optical fibers
Secospace USG6000
Issue 08 (2017-06-30)
NOTE
Set aside the dust cap properly for future use. After optical fiber are disconnected for maintenance, use
the dust cap to prevent the optical transceiver from dust.
NOTE
Ensure that the Tx and Rx ports are correctly connected.
8 9 10 11
SYS PWR MGMT
0 1 2 3 4 5 6 7 8
MGMT
2
0/1
ALM HDD MODE
3
1
0
RST
CONSOLE
1
3
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
9 10 11
Optical fiber
2
4
3 Hardware Installation
Optical interface
of the peer device
303