Table of Contents
Advertisement
Hardware description
N o t e
22
Avoid installing the unit in the following locations:
– Ambient temperatures outside the range of 0°C to 55°C/32°F to 131°F
– Ambient humidity outside the range of 30% to 85% RH
– Sudden temperature changes causing condensation
– Inflammable or corrosive gases
– Excessive airborne dust or metal particles
– Fuel, paint thinner, alcohol or other organic solvents or strong alkaline
solutions such as ammonia or caustic soda
– Excessive vibration or shock
– Direct sunlight
– Water in any form including spray or mist
Avoid noise interference from the following items:
– Influence from power transmission lines, high voltage equipment, power
cables, power equipment, radio transmitters, or any other equipment that
would generate high switching surges.
– If noise occurs in the power supply line even after the above
countermeasures are taken, it is recommended to supply power through an
insolated transformer, noise filter, or the like.
Measures regarding heat discharge:
– Always install the unit orientated with the Ethernet port facing outward on
the top in order to prevent the generation of heat.
– Do not install the unit above devices which generate heat, such as heaters,
transformers or large scale resistors.
Installation space:
– Leave at least 50mm/1.97in. of space between the wiring ducts of the unit
and other devices to allow heat radiation and unit replacement.
– Maintain a minimum of 100mm/3.937in. between devices to avoid adverse
affects from noise and heat when installing a device or panel door to the
front of the FP Web-Server unit.
FP Web-Server V2.810 EN
Advertisement
Table of Contents
