2 - 10 SB1 Integrator Guide
Wall Mounting
To mount the Ten Slot Charge Only Cradle and Mounting Bracket to a wall:
CAUTION
For proper installation consult a professional installer. Failure to install the Wall Mount Bracket properly can
possibly result in damage to the hardware.
Mark the four screw hole locations and drill holes.
1.
Screw Template
Figure 2-9
Install the four screws and/or anchors into the wall.
2.
The screw heads should protrude 2.5 mm (0.01") from the wall.
3.
Mounting Bracket onto Screws
Figure 2-10
Align the mounting bracket's mounting holes with the screws. Place the bracket/cradle assembly on the
4.
screws.
Slide the bracket/cradle assembly to the left and down.
5.
Rack Mounting
To mount the Ten Slot Charging Cradle onto a standard rack:
Use mounting hardware (screws and/or anchors) appropriate for the type of wall mounting the bracket
onto. The Mount Bracket mounting slots dimensions are 5 mm (0.2 in.). Fasteners must be able to
hold a minimum of 4.5 Kg (10 lbs.)
58.7 mm
2.31 in.
215 mm
8.46 in.