Standard Configurations Planning the Installation
Table 2-1. Dash and Remote O2, O3, O5, O7 or O9 Radio Power ON @ J2
Transceiver
Dash/Remote
Red Power
Mount
Wire
Connected to
X
battery
Connected to
ignition switch
Ignition switch
No ignition switch control.
controls
Table 2-2. Remote O2, O5, O7 or O9 Radio Power ON @ J200
Control Head
Remote
Red Wire
@J200
X
Connected to
battery
Connected to
ignition switch
Ignition switch
No ignition switch control.
controls
Part Number
HLN6863_
KT000274A01
DO NOT connect any wires to the battery terminals until you have finished the entire
!
radio installation (Dash or Remote Mount) configuration to avoid potential equipment
damage.
C a u t i o n
Incorrect wiring of the radio may result in incorrect ignition sense detection, incorrect
power-on state, or incorrect power-off state of the radio system.
The Control Head Power cable wire (RED) and Transceiver Power cable wire (RED)
are always attached to the battery terminal and NOT to the ignition switch.
MN003109A01_aa
Draft
HLN6863
Transceiver
Thin Red Wire
Red Power
@ J2
Wire
X
X
Enables ignition switch functionality
as programmed in the codeplug.
Control Head
Control Head
Yellow Wire
Red Wire
@J200
@J200
X
X
Enables ignition switch functionality
as programmed in the codeplug.
Table 2-3. Ignition Interface Cables
Description
Cable, M.A.P. 26pin with Only Ignition and SPK
Y-Cable, M.A.P to M.A.P. and DB 25
HLN6863
Transceiver
Thin Red Wire
Red Power
@ J2
Wire
X
X
Illegal wiring configuration. See
CAUTION note.
Control Head
Control Head
Yellow Wire
Red Wire
@J200
@J200
X
X
Illegal wiring configuration. See
CAUTION note.
2-17
HLN6863
Thin Red Wire
@ J2
X
X
Control Head
Yellow Wire
@J200
X
X