Motorola GP68 Operation Manual page 10

A high performance radio in a class of its own

Hide thumbs Also See for GP68:

To verify the frequencies programmed, from the Channel Display mode, press the X

key to toggle between Channel Display and Frequency Display modes. Rotate the

Channel Selector knob to the channel you want to verify, then press and hold the

ENTER button for three seconds.

You can check out all the settings...then, if NO changes were made, simply press

the X key momentarily to go back to Channel Mode display. If you DID make a

change or two, you will need to press the ENTER key for three seconds again - then

again momentarily - as in Step 6 above - to save the changes.

To Select the Receive PL/DPL Code

"Figure C"

2.Rotate the selector switch clockwise to increase, or counter

clockwise to decrease, the active Receive PL/DPL code.

Momentarily press any key to immediately adopt the selected

Receive PL/DPL code and return to normal operating mode (the

radio automatically does this after 3 seconds of inactivity).

The new Receive PL/DPL code is adopted.

To Select the Transmit PL/DPL Code

1.Press and hold

Receive PL code number (takes about 3 seconds). Press

momentarily to toggle the display to 'tPL." followed by the active Transmit PL code

number You can toggle between editing of the Receive and Transmit PL/DPL by

pressing

(SQL/B) momentarily. In the following example (Figure D), the

Transmit PL/DPL code is 020 (127.3/3A).

Press and hold

"rPL" followed by the active Receive PL

code number (takes about 3 seconds). In

the following example (Figure C), the

Receive PL/DPL code is 014 (103.5/1A).

(SQL/B) until the LCD displays "rPL." followed by the active

(SQL/B) until the LCD displays

(SQL/B)