Menu List - Sony DSM-R1 Operating Manual

Menu Setup

Menu List

Menu items are classified as one of the following
categories:
• Basic items (01~ and 10~ )
• Items about an optional board in the OUT1 section
on the rear panel (40~)
Item number Item
01 OUT1 SRC SEL
02 OUT2 SRC SEL
03 VIDEO STD
08 PASSWORD
11 FREQ BW
12 FEC RATE
17 L-BAND FREQ
18 LNB PWR VLTG
19 RF SPECTRUM
12
• Items about an optional board in the OUT2 section
on the rear panel (50~)
• Items about the front panel (80~)
• Items about the saving and recalling functions (90~)
The parameters in bold print are factory settings.
Parameter Function
SOURCE1 Selects the output signals from the optional board in
SOURCE2
the OUT1 section.
SOURCE1: Outputs the signals transferred from the
optional board in the IN1 section of the DSM-T1.
SOURCE2: Outputs the signals transferred from the
optional board in the IN2 section of the DSM-T1.
SOURCE1
Selects the output signals from the optional board in
SOURCE2 the OUT2 section.
SOURCE1: Outputs the signals transferred from the
optional board in the IN1 section of the DSM-T1.
SOURCE2: Outputs the signals transferred from the
optional board in the IN2 section of the DSM-T1.
525 Selects the broadcasting standard for which the unit is
625
set up.
525: 525 standard
625: 625 standard
0000 0001 Sets an 8 digits password. If the password of the
: DSM-T1 does not match that of this unit, no video/
FFFF FFFF
audio signals will be output from this unit.
If the PASSWORD of the DSM-T1 is set to "OFF" in
the menu, this unit outputs normal video/audio signals
regardless of the password of this unit.
36 MHz
Selects the frequency bandwidth.
18 MHz
7/8
Selects the Forward Error Correction rate.
3/4
950.000MHz When L-BAND is selected for RECEIVE BAND,
:
selects the output frequency from 950.000MHz to
1200.000MHz 2150.000MHz in 125KHz steps using cursor (4/$)
:
buttons or in 10MHz steps using cursor ("/") buttons.
2150.000MHz Parameters continue to change while the cursor button
is pressed and held.
OFF Selects whether or not to supply the power to the LNB
15.0V···22.0V (Low noise block converter) . When power is supplied
to the LNB, sets the voltage from 15.0V to 22.0V.
INVERSION Selects the input signal type (inversion or non-
NON-
inversion).
INVERSION