Menu Setup; Initial Display; Changing The Parameters - Sony DSM-R1 Operating Manual

Menu Setup

A menu is provided to set up the operating conditions
of the unit. Menu items include basic items, items
about the optional boards, items about the front panel,
etc.
For more information about menu items, see " Menu List"
(page 12).
A "current bank" and 8 "menu banks" are provided
with the unit. The current bank can be used to store
current parameters. The menu banks can be used to
store up to 8 sets of parameters. Saving/recalling
frequently used parameters in/from menu banks allows
faster setting up of the unit's operating conditions.

Initial Display

Switching power on causes one of the following status
display to appear.
• L-BAND FREQ: Displays the received frequency
when L-BAND is selected for RECEIVE BAND.
• L-BAND LEVEL: Displays the IF level input to L-
BAND. (TOO LOW/GOOD/TOO HIGH)
• C/N, BER: Displays the C/N level and bit error rate.
• TUNE STATUS: Displays the input L-Band
frequency gap. (LOW/GOOD/HIGH)
You can select any item using the ITEM Â or µ
button.

Changing the Parameters

Follow the procedure below to change the parameters
and save them in the current bank.
1,6
SOURCE ANALOG VIDEO FREQ FEC RF
SEL AUDIO STD BW RATE CONDITION ALARM
ALOG SOURCE1 SOURCE2 CH1/2 CH3/4
525 36M 7/8
625 18M 3/4
1
Press the MENU button.
The back lighting for the MENU button lights up,
and the menu appears in the display window.
10
2,4
MENU ITEM
ENTER
RESET
5
3,4
2
Select a menu item to be changed using the ITEM
 or µ button.
3
Change the parameters using the 4 or $ button.
Use the " or " button to move a digit to the left or
right.
4
To change the parameters of other items, repeat
steps 2 and 3.
5
Press the ENTER button.
The changed parameters are saved in the current
bank. The contents of the current bank are saved
even after the power is turned off.
To cancel changing parameters
Press the MENU button before pressing the
ENTER button.
6
Press the MENU button.
The back lighting for the MENU button turns off,
and the unit exits the menu.
To return the contents of the current bank
to the factory setting
Follow the procedure below.
1
Press the MENU button.
The back lighting for the MENU button lights up,
and the menu appears in the display window.
2
Select "93: FACTORY SET" using the ITEM Â or
µ button.
3
Press the ENTER button.
The contents of the current bank returns to the
factory setting.
To cancel returning to the factory setting
Press the MENU, ITEM Â or µ button before
pressing the ENTER button.
4
Press the MENU button.
The back lighting for the MENU button turns off,
and the unit exits the menu.