Dynamic Routing; Dns Relay - Siemens ADSL 50 User Manual

SANTIS ADSL 50/500 User Manual
Netmask:
Forward packets to: If you want add a rout on LAN side, you should choose the Gateway Address. Enter the

Dynamic Routing

Routing Information Protocol (RIP) is utilized as a means of exchanging routing information between routers. It
helps the routers to determine optimal routes. This page allows you to enable/disable this function.
By default, RIP is disabled with Disabled selected. You are allowed to enable RIP over the primary LAN interface.
Upon each interface, you can customize the RIP on Receive Mode and Transmit Mode respectively.
Receive Mode:
Transmit Mode:
DNS

DNS Relay

On this page you can choose to disable or enable DNS Relay function. If your DNS is disabled and you choose to
enable DNS relay, after selecting the Enabled option, please click Configure and then specify up to three DNS IP
addresses in the DNS server 1-3 IP address fields. Then click Apply to enable the DNS relay function.
If you log in DNS Relay page for the first time: when you choose Enabled and enter this page by clicking Configure.
50
The subnet mask of the destination IP address.
router address and then click Apply. If you want add a rout on WAN side, you should choose
the Interface. Select ATM PVC interface and then click Apply.
It incorporates the RIP information when receiving the RIP packets. From the drop-down list
select which RIP version should be accepted, RIP disabled, RIPv1, RIPv2 and both.
It broadcasts the routing table. From the drop-down list select which RIP version should be
broadcasted, RIP disable, RIPv1, RIPv2 and both.