Taking The Engine Out Of Operation For More Than 12 Months - ABB TPS48-H33 Operation Manual

Operation Manual / 4 Product description / TPS44-H.. - TPS52-H..
11 Mothballing the turbocharger
Rotation of the rotor in the stack draught
The rotor can rotate in the stack draught. If the bearings are not lubricated,
this can result in wear.
CAUTION
Install blind flange between gas outlet casing and exhaust gas pipe.

11.2 Taking the engine out of operation for more than
12 months
If the engine is taken out of operation, the following variants are possible with regard to the
turbocharger:
 Turbocharger remains attached to the engine
 The casings of the turbocharger remain attached to the engine, the rotor and bearing parts
are dismantled by an ABB Turbocharging Service Station and stored separately
 The turbocharger has been completely removed, either as a whole unit or in individual
parts
For the measures always necessary for preparing the turbocharger parts for mothballing, see
section Taking out of operation for up to 12 months, subsection Preparations for mothballing.
If the turbocharger remains attached to the engine, see section Taking out of operation for up
to 12 months, subsection Rotation of the rotor in the stack draught.
If the complete turbocharger is removed or the turbocharger is fitted again from the individual
parts:
Seal all openings of the turbocharger with paraffin paper and wooden lids.

Only dry rooms with 40 ... 70 % atmospheric humidity, in which no water condensation can
form, are suitable as storage locations.
State of the mothballed turbocharger
Check the turbocharger parts annually for corrosion.

If there are signs of rust: Thoroughly clean parts and renew corrosion protection.

© Copyright 2016 ABB. All rights reserved. HZTL4037_EN
Page 90 / 99
Revision A August 2016