Table of Contents
Advertisement
[Example] The procedure to set separately QueueDepth of hfcldd0 to 20 while setting the other
adapters across all the ports to 10 is shown below on Linux:
(Step 1) Refer to the set value of hfcldd0.
Each item name: The current driver operation value (value set to hfcldd.conf/FLASH-
ROM) is
indicated.
(-) indicates yet-to-be-set.
Figure Sample of hfcmgr –p display
# ./hfcmgr -p hfcldd0
Time: xxxx/xx/xx xx:xx:xx
--------------------------------------------------------
WWPN:50000870003021e0 Device:hfcldd0 [LinkUp]
--------------------------------------------------------
Connection Type
Link Speed
Max Transfer Size
Login Delay Time
Link Down Time
Reset Delay Time
Preferred AL-PA
Reset Timeout
Abort Timeout
Queue Depth
Machine Check
Allowed
Target Reset Mode
LUN Reset Delay
Interrupt Type
Logging Mode
Login Target Filter : none (-)
# ./hfcmgr –p
1: WWPN:50000870003021e0 Device:hfcldd0 [LinkUp]
2: WWPN:50000870003021e2 Device:hfcldd1 [LinkUp]
Enter number > 1
: Point to Point[fabric] (Point to Point)
: 1Gbps (1Gbps)
: 16 MB (-)
: 2 sec (3)
: 15 sec (-)
: 19 sec (-)
: 0x01 (-)
: 20 sec (-)
: 8 sec (-)
: 32 (-)
: 8 (-)
: 5 (-)
: off (-)
: 0 (-)
: Legacy Mode (-)
: default (-)
If any port is not passed as a command-
line parameter, enter the number of the
port here to display the port information.
44
Advertisement
Table of Contents
