Table of Contents
Advertisement
[Response messages]
No Response message
1
Succeeded.
2
The adapter port has already isolated
3
The adapter port status is CHECK-
STOP.
4
Not support, LPAR mode.
5
This
Firmware
support hot swap feature of SFP
Transceiver.
Execute Recover SFP
You can recover the adapter port selecting 'Select SFP Operations'-' 3. Recover SFP'.
You have to recover SFP after replacing SFP while OS in operation.
--------------------------------------------------------------
Hitachi HBA Utility for Linux. Version 1.0.2.65 (06/17/2009)
Copyright (c) 2004-2009, Hitachi Ltd.
--------------------------------------------------------------
Main Menu
---------
1 . Display Current Component
2 . Display Auto Map Parameter
3 . Set Auto Map Parameter
4 . Display HBA Adapter Number
5 . Modify HBA Adapter Number
6 . Display Current Persistent Bindings
7 . Modify Persistent Bindings
8 . Display HBA Parameters
9 . Set HBA Parameters
10. SFP Transceiver Replacement
99. Exit
Enter number => 10
Select SFP Operations:
1 . Display SFP Information
2 . Isolate SFP
3 . Recover SFP
99. Cancel
Enter number => 3
Enter adapter <Device Name>
Do you execute it? (Y/N) :y
Succeeded.
Return to Main Menu =>
version
does
not
( hfclddx, X to Cancel ) => hfcldd0
114
Meaning
Normal end
The specified port has been already isolated.
Comfirm the port status using'1. Display SFP
Information'.
The specified port is check stopped state.
Comfirm the port status using'1. Display SFP
Information'.
LPAR guest does not support this command.
Adapter firmware does not support SFP
isolate command.
Advertisement
Table of Contents
