Enable Tpm - NEC Express5800 Series User Manual

Chapter 2 Preparations
7. See Chapter 2 (1.5 Top Cover)to attach the top cover of the server.
8. Please see Chapter 2 (2. Installation and Connection) in this manual to conduct installation and connection,
and turn the power supply ON
1.6.2

Enable TPM

The server will restart twice without user input. TPM setting is enabled after restarting and POST is complete.
You can now make use of Microsoft Windows BitLocker using TPM and major boot etc. according to above.
If you need detailed information on the update of firmware and the procedure of hardware, refer to the Web Site
of NEC Support Center.
For more information about how to configure the TPM to using BitLocker, see the Microsoft Web site.
56
Note
In order to prevent damage of the system due to improper cooling or elevated
temperature, please do not activate the server or enclosure without implementing
any of component or blank on all of drive bays and device bays.
Important
TPM Kit once installed cannot be removed.
Ask your sales representative if you want to remove the TPM kit.
Note
When enabling TPM, and operating it as below please follow the appropriate steps.
Data access will be blocked if the operation is incorrect.

Updating system and firmware of options

Replacing system board

Replacing hard disk drive

Modifying OS application TPM settings
Express5800/R120h-1E User's Guide
1. Installing Internal Optional Devices