Mitsubishi Electric C80 Series Instruction Manual page 359

C80 Series Instruction Manual
9 Machining a Workpiece
Precautions
(1) When registering the stop position (O, N, B values), confirm that the block exists in the searched program. Collation and
stop will not be executed if the corresponding block is not found at the registered stop position.
(2) Always set one of the O, N or B numbers. If nothing is set, a setting error will occur.
(3) If the O No. is not set, the O No. used during operation search will be used.
(4) If the N and B numbers are not set, the block will be searched using the O No.
(5) If there are several sequences and blocks with the same number in one program, collation and stop will be executed
after executing the first block that matches in the execution order.
(6) The settings are canceled when collation and stop is executed.
(7) The settings are canceled when reset is executed.
(8) If only the program number is set, collation and stop will take place at the head of the program only when there is a
program number at the first line.
(9) Collation and stop cannot be performed or canceled for blocks being executed or blocks already read into the preread
buffer.
(10) Collation and stop is not performed in the tapping mode.
(11) Collation and stop is possible in a subprogram, but is not possible in a MTB macro program.
(12) If collation and stop is set for a fixed cycle block, it will be executed after the positioning block is completed.
(13) Collation and stop is possible even when editing is locked.
(14) Collation and stop is executed after executing the block set for the collation and stop position. If the position is set in a
program call (M98) block, collation and stop will be executed before the subprogram is called.
(15) If the set block is set to be skipped, collation and stop will not be executed.
(16) The collation and stop position can be registered for each part system.
(17) The stop position cannot be registered during verification.
(18) Registration of collation and stop position is not possible for a program with 33 or more file name characters.
IB-1501453-C 334