C80 Series Instruction Manual
6 Setting Parameters
6.1.4 Parameter Configuration
The parameter number range and permissible operations for all parameter types are shown below.
○: Can be used
∆: Operable under certain conditions (Refer to the section below for conditions.)
Parameter type
Fixed cycle parameter
Fixed cycle
Control parameter 1
Control parameter 2
Ethernet parameter
Axis parameter
Barrier data (*4)
High-accuracy control pa-
rameter
High-accuracy control axis
parameter
Operation parameter
Menu selection parameter
(*1) This is valid only when the total number of valid NC axes and PLC axes in the entire part system is four or more.
(*2) This is valid only when the total number of valid NC axes and PLC axes in the entire part system is two or more.
(*3) This is valid only when the number of valid part systems is two or more.
(*4) The barrier data appears only for L system.
6.1.5 Echoback
When 13 or more characters are set for Ethernet parameter to be echoed back, the set value is displayed in the input area
and displayed in the data column with "...". When the cursor moves to a parameter which is not subject to echoback, the
contents in the input area will be deleted.
6.1.6 Ethernet parameter
If the Ethernet parameter "Host 1 password" to "Host 4 password" is set, "********" displays regardless of the password char-
acters set in that data field.
6.1.7 Precautions
When the data protection is valid, the value cannot be set (including paste operation) for the high-accuracy control param-
eters (part system based) and high-accuracy control axis parameters.
Menu [Next axis] System change key Menu [Area copy] Menu [Area paste]
-
∆ (*3)
-
∆ (*3)
-
-
-
∆ (*3)
-
-
∆ (*1)
-
-
∆ (*3)
-
∆ (*3)
∆ (*1)
-
-
-
-
-
241
∆ (*3)
∆ (*3)
∆ (*3)
∆ (*3)
-
-
∆ (*3)
∆ (*3)
-
-
∆ (*2)
∆ (*2)
○
○
∆ (*3)
∆ (*3)
∆ (*2)
∆ (*2)
-
-
-
-
IB-1501453-C