3 . Use two or more screws to fix the rear cover of the Wi-Fi kit to a wall . Then, connect the power cable (V1, V2) and the
communication cable (F1, F2) to the terminals on the back of the front cover in appropriate length .
4 . When connecting the V1 and V2, tighten the screws for the terminal block (CN5) with a tightening torque of 5 ±2 N·cm .
Size of the screw is M3 x 6 .
• Maximum number of indoor unit installation that can be connected to Wi-Fi kit is 16 .
• One Wi-Fi kit can be registered with maximum 5 users .
NOTE
- If you register more than 5 users to single Wi-Fi kit, its operation may become slower .
• Each account (one mobile phone) can be registered with maximum 4 Wi-Fi kits .
10 mm
(9/16 inch) or more
10 mm
(9/16 inch) or
more
50 mm (2 inches)
or more
❋ ❋ Before fixing the rear cover, allow
10mm or more space for upper,
left, and right sides and 50mm
space for bottom side .
Item
Ⓐ
Power/communication connection terminal
Ⓑ
Tracknig/Initializing button
Ⓒ
SD Card Slot
Ⓓ
LED
Ⓔ
Network PBA
Ⓕ
Interface module PBA
MULTI WIFI APP-NA_05417A-05_EN.indd 7
10 mm
(9/16 inch) or more
Screw
fixing
hole
Rear cover
❋ ❋ Fix the screws in the
provided screw holes .
Contents
Indoor unit
Ⓔ
Ⓕ
V1 V2 F1 F2
❋ ❋ Do not tighten the PCB terminal with
too much force .
2018-02-28 오전 11:08:32
Ⓑ
Wi-Fi kit
Ⓓ
Ⓒ
Ⓐ
PCB
terminal
7