Remote Mount Installation - Motorola Cleartone CM5000 Installation Manual

INSTALLATION

Remote Mount Installation

(Remote Mount with Junction Box)
To CM5000
accessory connector
Connecting cable
General
The junction box (GMLN3002_) assists the easy installation for dash and remote mount
configurations. It furthermore provides access to the radio for flashing and keyloading of Universal
Cryption Module (UCM) encryption keys.
The junction box enables the customer adding a laptop to the remote configuration and connecting
various accessories.
Installation
The junction box can be installed horizontally and vertically. Secure the junction box by screwing the
four supplied screws straight into the location as shown in the figure below. Use the connecting
cable (1) for installation purposes.
Ingress Protection (IP) Code: IP30
The junction box has no connector sealing and is designed for use in dust and water protected
location only.
1. Secure the junction box (GMLN3002_) with the four screws supplied with kit.
2. Connect the connection cable GMKN4192_ (length = 6 m), GMKN4193_ (length = 4 m) or
GMKN4194_ (length = 2 m) from the junction box to the accessory connector on the rear side
of the transceiver and fasten it with the plug-screws.
The cable which will be used for installation purposes only must be ordered separately.
3. All other devices should be adapted as shown in figure 14.
CM5000 TETRA Mobile Repeater/Gateway Installation Manual
Speaker
External PTT
GMKN4192/3/4
Junction Box
GMNL3002_
Programming Cable
FLN9636_
Figure 12 Remote Mount Installation with Junction Box
Visor microphone
To Ignition
GMMN1033_
switch
F2 4A
External
alarm
Emergency
switch
Fist Microphone GMMN4063_ or
Telephone style handset GMUN1006_
Accessory
Connector Kit
GMBN1021_
Standard
RS232 cable
Laptop
Laptop
37