Samsung SP-A800B Owner's Instructions Manual page 11

When temperature inside
Action 3 of the projector becomes
too high.
When the DDP IC or color wheel
Action 4
fails to operate.
The lamp is
malfunctioning after
Action 5 abnormal power off or
restarting right after
turning off the projector.
When the screen becomes
Action 6
darker
This Projector uses a cooling fan system to keep the unit from overheating. Operation of the cooling fan may
cause noise, which does not affect the product performance. No exchange or refund for the noise concern.
Rear Side
1. PC IN Input port
2. COMPONENT IN Input port
3. S-VIDEO IN Input port
4. POWER Input port
installation precautions listed above. Cool down your projector
sufficiently and then operate it again. If the same problem occurs
continually, contact your product distributor or
Disconnect and reconnect the power cord and start the projector
again. If the same symptom still occurs, contact your product
distributor or service center.
Turn the power off, wait for a sufficient amount of cooling time and
then turn the power on for operations. If the same problem occurs
continually, contact your product distributor or
Check the lamp usage time on the Information Display screen. If you
need to replace the lamp, contact your product distributor or
center.
5. RS-232C port
(For service input terminals)
6. VIDEO IN Input port
7. Remote Control Signal Receiver
8. HDMI IN 2, HDMI 1/DVI IN Input port
service center.
service center.
service