Table of Contents
Advertisement
3. Select Connect � Remote System.
The Connect window appears.
4. Type the IP address of the D6680 into the
Host Name field:
•
Use the IP address that was assigned to the
D6680 in Section 3.4 Initial Assignment of the IP
Address using ARP on page 7.
•
Type 1 in the Port field
•
Accept vt100 in the TermType field
The IP and MAC addresses used in this
example are not the same as the numbers
you are using. This is for demonstration
only.
5. Click [Connect]. A Connect failed message
appears: Could not open a connection to
<IP address>.
6. Click [OK]. The Telnet window appears again.
Select Connect � Remote System again.
Bosch Security Systems, Inc. | 5/07 | 4998138732-01
Conettix D6680 | Installation Instructions | 3.0 Configuration and Programming
Available from A1 Security Cameras
www.a1securitycameras.com email: sales@a1securitycameras.com
7. On the Connect dialog box:
a. Type 9999 in the Port field.
b. Accept the values in the Host Name and
TermType fields.
Read steps 7c, d, and e. You must do
steps 7d and 7e quickly after step7c.
If you do not press ENTER within five sec
of seeing the message, you are
disconnected.
c.
Click the Connect.
d. Observe the software version that appears
briefly.
e.
Press the ENTER key within five sec of seeing
the message.
The program prompts you to press [ENTER] by
displaying Press Enter to go into setup
mode.
8. If you pressed [ENTER] within five sec, you
should see the following screen (refer to Figure 11
on
page 10).
The software version shows briefly before
the [ENTER] key is pressed. Pressing
[ENTER] forces the screen to scroll and the
software version will no longer be visible.
Note the software version during the five
sec interval.
9
Advertisement
Table of Contents
