HP Indigo 5000 Preventive Maintenance Manual page 11

Inline densitometer
Lubrication
BID engage
Ventilation system
Print quality
CA294-00570
2 Million Imp - Preventive Maintenance Guide - HP Indigo press 5000
Print a new reference densitometer full calibration strip, if one is
not available, and perform the validation procedure. See the HP
Indigo service instruction for the Inline Densitometer.
Instruct the operator to store the strip in a dark, clean place.
Make sure that all lubrication points have been oiled and greased
properly. See "Appendix C - Grease and oil types" on page 17.
Make sure that all lubrication points have been oiled and greased
properly, including the exit elevator gears and chains. See
"Appendix C - Grease and oil types" on page 17. For a complete
list, check the User Guide, or view the press On-line
documentation videos (OPD).
Verify that the BID fans are working properly.
Make sure that all the Amateks are working properly:
Scorotron (suction and blower).
ITM input fan.
Air knife (suction and blower).
Bottom cooling.
Perform the following:
Print Fine_Tune job, adjust if necessary.
Print a gray_20 job, and verify the quality of the print.
Check writing head deskew, and adjust, if necessary. Use the
gray_20 job to observe banding of ~3.5 mm along the format that
appears due to an incorrect deskew adjustment.
Print the CATP job. Check the press performance according to
the table of specifications attached to the job.
Send 2 copies of each job, marked with the press serial number
and the date, to your service center.
rev 01 page 11 of 18