Disassembly Procedure; Disassembling The Dm2000; Removing The Sp2000; Removing The Mb2000 - Yamaha DM2000 Service Manual

DISASSEMBLY PROCEDURE

Note: Take care not to trap your fingers.
After replacing the circuit board or fader of FD1 or
FD2, please initialize them. (See page 187.)

Disassembling the DM2000

1.

Removing the SP2000

(Time required: About 5 minutes)
1-1. If the SP2000 is attached to the DM2000, remove
the twelve (12) screws marked [A], and then both
sides must be removed. (Fig.1)
2.

Removing the MB2000

(Time required: About 5 minutes)
2-1. Loosen the four (4) screws marked [B]. The MB2000
can then be removed from the DM2000. (Photo.1,2)
Photo.1
3. Control Panel Assembly
(Time required: About 10 minutes)
3-1. Remove the SP2000. (See procedure 1.)
3-2. Remove the MB2000. (See procedure 2.)
3-3. Remove the twenty (20) screws marked [60A], the
eight (8) screws marked [60B] and the seven (7)
screws marked [60C]. (Fig.2)
3-4. Hold the LCD assembly part, and lift the control panel
assembly. And then, fasten them by the two (2) front
stays. (Photo.3)
When assembling the control panel assembly
with the side panel, put the screws of the
round screw hole of the side panel in place
first, then the screws of the elliptic screw hole.
[A]: Bind Head Screw
Meter angle L, R
[B]: Bind Head Screw
DM2000
SP2000
(Side pad)
SP2000
[A]
(MB side pad)
4.0X16 MFZN2BL (EG340110)
Fig.1
MB2000
[B]
DM2000
A4.0X12 MFZN2BL (VP156900)
Photo.2
DM2000
41