TÜV
The TÜV confirms that the HMI device satisfies the requirements of the following standards
with regard to its safety functions.
Standard
DIN EN 60204-1
DIN IEC 62061
IEC 61508-1 to 4
ISO 13850
ISO 13849-1
Additional measurements
Additional measurements were made for:
● Japan
– Table/Annex No 43,44,45 – Test Method for Radio Equipment mentioned in
– Table/Annex No 47 – Test Method for Radio Equipment mentioned in Certification
– RFID – ARIB STD T-82
● Taiwan
– LP0002
2.4
Operating conditions
The national approvals for the HMI device are listed on the back of the device and in the
product information for "Wireless Teach Pendant F IWLAN V2" in the Internet
(http://support.automation.siemens.com/WW/view/en/30360848/133300).
NOTICE
Wireless control device
A wireless control device may cause interference.
If a wireless control device is used, the following must be ensured:
That other systems at the site are not disturbed by the wireless control device
That other systems at the site do not disturb the wireless control device
Wireless Teach Pendant F IWLAN V2
Operating Instructions, 08/2010, A5E02453837-01
Title
Safety of machinery – Electrical equipment of
machines – Part 1: General Requirements
Safety of machinery – Functional safety of electrical,
electronic and programmable control systems for
machinery
Safety Integrity Level 3
Safety of machinery - EMERGENCY STOP -
Principles for design
Performance Level e and Category 4
Certification Regulations Article, Item 19, 19-2, 19-3 and 19-3-2
Regulations Article, Item 19-5 and 19-11
PRELIMINARY II
1.7.2010
Safety instructions and standards
2.4 Operating conditions
Version
01.10.2009
01.04.2009
01.01.2005
01.01.2009
01.09.2009
39