Sony HDR-AS200V Startup Manual page 16

About the water-proof performance of the remote control
The remote control is designed to be water-proof. Damage caused
by misuse, abuse, or improper maintenance is not covered by the
limited warranty.
• Do not subject the remote control to pressurized water, such as from
a tap.
• Do not use in hot springs.
• Use the remote control in the water temperature range of 0 octo 40
oc (32 oF to 104 °F).
Notes before using the remote control under/near water
• Make sure that no foreign matter such as sand, hair, or dirt gets inside
the connector cover. Even a small amount of foreign n'\atter may lead
to water entering the remote control.
• Confirm that the sealing gasket and its mating surfaces have not
become scratched. Even a small scratch may lead to water entering
the remote control. If the sealing gasket or its mating surfaces
become scratched, consult your Sony dealer or local authorized Sony
service facility.
• If dirt or sand gets on the sealing gasket or its mating surfaces, wipe
the area clean with a soft cloth that does not leave behind any fibers .
• Do not open/close the connector cover with wet or sandy hands or
near water. There is a risk of sand or water 9etting inside. Before
opening the connector cover, perform the procedure described in
"Cleaning after using the remote control under/near water".
• Open the terminal card cover when the remote control is completely
dry.
• Always check that the connector cover is securely locked.
Notes on using the remote control under/near water
• Do not subject the remote control to shock such as by jumping into
water.
• Do not open and close the connector cover while under/near water.
• The remote control sinks in water. Use the belt supplied with the
remote control to prevent it from sinking.
Cleaning after using the remote control under/near water
• Always clean the remote control with water within 60 minutes of use,
and do not open the connector cover before cleaning is finished. Sand
or water may get inside where it cannot be seen, and will degrade
water-proof performance if not rinsed out.
• Allow the remote control to sit in pure water poured into a cleaning
bowl for about 5 minutes. Then, gently shake the remote control and
press each button under the water to clean away any salt, sand or
other matter lodged around the buttons.
• After rinsing, wipe away any drops of water with a soft cloth. Allow
the remote control to dry completely in a shady location with good
ventilation. Do not blow dry with a hair dryer as there is a risk of
deformation and/or degraded water-proof performance.
• Wipe away any drops of water or dust from the connector cover with
a soft dry cloth.
• Bubbles may appear when the remote control is placed underwater.
This is not a malfunction .
• The remote control body may become discolored if it comes into
contact with sunscreen or suntan oil.
If the remote control does come into contact with sunscreen or
suntan oil, quickly wipe it
clean.
• Do not allow the remote control to sit with salt water inside it or on its
surface. This may lead to corrosion or discoloration, and degradation
of the water-proof performance.
Disposal
Remove the battery pack before disposing of the remote control.
Remove the battery pack
The built-in battery pack is recyclable.
When disposing of the remote control, remove the built-in battery
pack ·
Notes
When removing the battery pack, be careful of the following .
• Remove the screws, etc. away from small children to prevent accidental
swallowing.
• Be careful not to injure your nails or fingers.
Important information
Do not remove the screws except when disposing of the remote
control.
We will refuse repairs or replacement if we judge there to have been
unwarranted disassembly.
-
1 Press the ON/OFF button to turn off the power of the remote control.
2
3
4
5
Disconnect the connected cables.
Remove the screws with a Phillips-head screwdriver. {4 screws)
Detach the cover.
Push the hook outwards and remove the battery pack.
f
r
Specifications
Power requirements: Rechargeable battery pack: 3.6 V (Internal
USB charging :
Charging time :
battery)
Multi/Micro USB Terminal: 5.0 V
DC 5.0 V, 500 mA/800 mA
Via a computer: Approx. 4 h and 5 min.
Via a AC-UD10 (sold separately): Approx. 2 hand
55 min .
Waterproof performance:
Depth of water 3 m (10 feet), 30 minutes ·
continuously (The waterproof performance is not
guaranteed under all circumstances)
Operating temperature:
-10 octo +40 oc (14 oF to 104 °F)
Storage temperature: -20 octo +60 oc ( -4 oF to+ 140 °F)
Dimensions (Approx.):
72.3 mm x 50.2 mm x 20.8 mm
(2 7/8 in. x 2 in . x 27/32 in .)
(W/H/D, excluding protrusions)
Mass : Approx. 64 g {2.3 oz) (only the main body)
Total weight (when in use):
Approx. 95 g (3.4 oz)
(including the supplied belt and base plate)
Included items: Live-View Remote (1), Micro USB cable (1)*, Belt (1),
Base plate (1), Set of printed documentation
*
Even if the remote control is sold with the camera, only one micro USB cable is
included.
• Design and specifications are subject to change without notice for
future upgrade.
• For more specifications, refer to the online Help Guide.
On trademarks
• Wi-Fi, the Wi-Fi logo, Wi-Fi PROTECTED SET-UP are registered trademarks of the
Wi-Fi Alliance.
• Adobe, the Adobe logo, and Adobe Acrobat are either registered trademarks or
trademarks of Adobe Systems Incorporated in the United States and/or other
countries.
In addition, system and product names used in this manual are, in
general; trademarks or registered trademarks of their respective
developers or manufacturers. However, the
TM
or
®
marks may not be
described in this manual.