Sony HDR-AS200V Startup Manual page 14

3
Check the camera settings.
Check that a Wi-Fi mark is displayed on the display panel of the
camera .
Action Cam excludin9
HDR-AZ1
Notes
HDR-AZ1
l
'"r•,
.!::::f
mil
• If the connection mode of the camera is set to the multi connection, switch
to the single connection.
• For
HDR-AS15/AS30y,
insert a memory card to the camera.
4
Select the camera you want to connect to the remote
control. ·
CD
Select the SSID (the destination) from the connection
destination list.
®Press the REC/ENTER button .
®When the remote control is in the standby status, proceed to
step 5 within 2 minutes.
~ ® ®
~~
+
[~ [ ~ j)
+
~ ~@
If you press the REC/ENTER button in the status illustrated in
@,
the remote control will be released from the standby status. In this
case, select the SSID of the camera again .
5
Connect the remote control to the camera .
Action Cam excluding HDR-AZ1
When [ACPT?] is displayed on the display panel of the camera,
press the ENTER button of the camera.
R[,OT]
Notes
• If [ACPT?] is not displayed on the display panel of the camera, restart the
camera and try again from step 3.
HDR-AZ1
When you hear the connection confirmation beep, press and hold
the Wi-Fi button of the camera until you hear the connection
completion beep.
+
Notes
• For
HDR-AZ1,
the connection confirmation beep does not sound if
l...P
(Beep) is set to OFF.
• If the connection confirmation beep does not sound, restart the · c amera
and try again from step 3.
The REC/Wi-Fi lamp lights in blue, the LCD screen of the remote
. control switches to the Live-View display and connection is
established .
Notes
• If the connection to the camera is not completed, the signal traffic may be
heavy. In this case, move to another location and try again.
Switching shooting modes
Switch the shooting mode by pressing the UP/DOWN button on the
Live-View display of the remote control.
The shooting mode icon will be displayed on the upper left side of the
display.
Recording
When recording movies
For details on the following operations, refer to the online Help Guide
or the operating instructions of the camera .
• Still images
• Interval still images
• Loop recording
1
Press the REC/ENTER button to start recording .
The REC/Wi-Fi lamp turns from blue to red .
2
Press the REC/ENTER button again to stop recording .
The REC/Wi-Fi lamp turns from red to blue.
Notes on attaching a belt to the remote control
• You can adjust the belt length depending on the pasting position of
@and@.
• To fasten the remote control to your arm, wear it on the back of your
hand . Then, thread the belt through©. facing .the REC/ENTER button
toward your fingertips; and the LCD screen toward you r elbow.
After attaching @, move® to cover the end of@. ·
• Attaching the belt incorrectly may cause injury.
• When placing the remote control on your right arm, set the screen
rotation in the remote control settings to ON .
• When using the remote control attached to your arm, always attach
the supplied base plate and belt correctly.
• Be careful not to drop the remote control when unfastening the belt.
• For details on attaching the belt to the remote control, refer to the
Help Guide.