Locating Internal Modules; Removing Chassis Covers - HP FlexNetwork MSR3064 Installation Manual

Locating internal modules

Removing chassis covers

WARNING!
• To avoid bodily injury and equipment damage, make sure all power supplies connected to the
router are powered off, all power cords and interface cables are removed before you maintain the
hardware.
• Wear an ESD wrist strap and make sure it makes good skin contact and is reliably grounded.
• After you maintain the hardware, reinstall the chassis cover.
Removing the chassis cover from the MSR3012/MSR3024
Place the router on a flat ground and have the rear panel face you.
1.
Use a Phillips screwdriver to remove the screws on the rear panel and the screws on the left
2.
and right sides of the chassis.
Rotate a flat-blade screwdriver to separate the chassis and the cover as shown in
3.
Raise the chassis cover until its front edge is separated from the chassis bottom completely.
4.
Pull the chassis cover towards you until the tab on the back edge is disengaged from the front
5.
panel, and put away the cover.
Figure 51 Removing chassis cover screws
Figure 52 Rotating the flat-blade screwdriver
40
Figure 52.